Make your own free website on Tripod.com

The Reality Manipulator

How to make a cadeus coil
Home | other device | How to make a cadeus coil | How to use the Reality manipulator | How to build the Reality manipulator | Contact Us/Link

Here the instructions on how to make a cadeus coil.

Take one 21awg wire then cut it at 18 to 12 foot depending on the room inside your device , then hook on end the loopy end side to anything that could hold it , then attacht eh free end to your drill then start twisting , it should shrink down to 10 to 6 long , be carefull because once twisted it will want to entertwine on itself , then just roll in inside your device like the picture below , for sure hot glue always help and you must be patient because you might not succeed into winding it on your first try . good luck

the lenght may vary on the room you have inside
cadeus2.jpg
your device

should look somewhat like that
cadeus.jpg

If you wish to purchase one already made and tested contact us at